Difference between revisions of "Spawn Settings"
From ASSS Wiki
(reworded most of the page) |
m (i think i fixed a typo) |
||
| Line 1: | Line 1: | ||
| − | [Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses | + | [Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses Team1, etc.). This will also occur if you only define Teams 0 and 1 (Team2 will use Team0 and so on). |
Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear. | Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear. | ||
Revision as of 09:30, 25 July 2006
[Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses Team1, etc.). This will also occur if you only define Teams 0 and 1 (Team2 will use Team0 and so on).
Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear.
TeamN-X
Datatype: Tiles.
The X coordinate in tiles for the center of frequency N's spawn.
TeamN-Y
Datatype: Tiles.
The Y coordinate in tiles for the center of frequency N's spawn.
TeamN-Radius
Datatype: Tiles.
The radius in tiles for frequency N's spawn. 0 is allowed.
