Difference between revisions of "Spawn Settings"
From ASSS Wiki
(reworded most of the page) |
m (added example) |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
− | [Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses | + | [Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses Team1, etc.). This will also occur if you only define Teams 0 and 1 (Team2 will use Team0 and so on). |
+ | |||
+ | Example: | ||
+ | <pre> | ||
+ | [Spawn] | ||
+ | Team0-X=400 | ||
+ | Team0-Y=400 | ||
+ | Team0-Radius=8 | ||
+ | Team1-X=600 | ||
+ | Team1-Y=600 | ||
+ | Team1-Radius=8 | ||
+ | </pre> | ||
Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear. | Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear. |
Latest revision as of 16:29, 7 October 2006
[Spawn] Use these settings to customize team spawns. It is safe to leave them blank, omit these settings, or leave them all set to 0 (zero). Note that the teams will repeat through this list (Team4 uses Team0, Team5 uses Team1, etc.). This will also occur if you only define Teams 0 and 1 (Team2 will use Team0 and so on).
Example:
[Spawn] Team0-X=400 Team0-Y=400 Team0-Radius=8 Team1-X=600 Team1-Y=600 Team1-Radius=8
Team0 through to Team3 are available, but for ease of demonstration N will be used where the number should appear.
TeamN-X
Datatype: Tiles.
The X coordinate in tiles for the center of frequency N's spawn.
TeamN-Y
Datatype: Tiles.
The Y coordinate in tiles for the center of frequency N's spawn.
TeamN-Radius
Datatype: Tiles.
The radius in tiles for frequency N's spawn. 0 is allowed.